basic DALI installation – Broadcast control
Project scope
- office with 2 (-10) luminaires combined to 1 group
- Broadcast control
- Sensor for movement / presence
Light turns on when movement / presence is detected and turns off after 10 mins of absence - Sensor for constant light control (energy saving)
light control depending on the brightness inside a room - Manual control
Manual on / off (switch)
Manual dimming: switches off constant light control (sensor for movement / presence is detection remains active)
Featured topics
- Planning DALI light installation
- Required DALI devices
- Setup and configuration with DALI Cockpit Software

Planning DALI light installation
Initial installation
- small Office with work place and small meeting table
- 2+ luminaires
- manual control (light switch at entrance)
DALI light management
- integration of conventional light switch in DALI System (DALI Power Supply and DALI MC+)
- all luminaries combined to 1 group -> Broadcast control
- Movement / Presence sensor
Required DALI devices



1x
Art.Nr.:86459532 DALI MC+
-> go to product page
DALI MC+: push button coupler
Button 1: switch on / dim up
Button 2: switch off / dim down
1x
Art.Nr.:24033444-30 DALI PS 30mA
-> go to product page
DALI power supply with 30mA (up to 10 luminaires plus controls)
Mounted in Back box with DALI MC+
1x
Art.Nr.:86458621-ZD DALI CS ceiling
-> go to product page
DALI CS Sensor: movement and light sensor
Required for setup and configuration
Setup and configuration with DALI Cockpit Software
Step 1: General
Step 2: DALI MC+
setup T1-to T2 -> Input 1 to Input 2 in DALI Cockpit
Step 3: DALI CS
Tab “Settings”
- in the section “Operating Mode” select: “Presence Triggered Lighting Control and Constant Lighting Control”
Tab “Motion Sensor”
- Destination Address: All (DALI Broadcast)
- Max Command (1): RECALL MAX
- Mid Level Command (3): Light Level (DAP)
Light Level: 15%
Fade Time: [4] 2 sec - Off Command (5): OFF
- Hold on time (2): 10min
- Second level Hold on time (4): 5 min
- Lichtsensor – Start Corridor Function: select: “Cmd X is independent from Light sensor“
Tab “Light Sensor”